AMI zone inside overset zone
Functionality to add/problem to solve
Is it possible to run an AMI zone within an overset mesh zone? My case involves a cycloidal propeller, in which five blades will rotate together as a single overset mesh zone, and then each single blade will independently vary its pitch as an embedded AMI within the enclosing overset mesh.
(Who will benefit from the changes?) Turbomachinery folks and complex geometry folks.
(How are we going to solve the problem?) Hair pulling with lots of new bookkeeping.
What does success look like, and how can we measure that?
(What are the success factors and acceptance criteria? e.g. test cases, error margins) Solve the above referenced test case.
Links / references
(Links to literature, supporting information) None.
(Does the functionality already exist/is sponsorship available?) Not sure if Ansys Fluent supports this. No known sponsorship possibilities.