- downgrades some diagnostics about nonconformant code from errors to
  warnings. Oddly enough, the errors actually arise from STL library
  elements shipped with gcc itself. Affects kahip compilation with
  gcc-6, gcc-7

The minimum number of particles per parcel can now be set in the
injection model input, e.g.:

    model1
    {
        type            ...;
        massTotal       ...;
        parcelBasisType ...;
        minParticlesPerParcel 1; <-- new optional entry
        SOI             ...;
        ...

Uses a value of 1 by default if the entry is not present.  The value of
1 is generally recommended and beneficial for coupled cases where small
time steps can lead to the injection of too many parcels and subsequently
greatly over-predict the particle source contributions (momentum, heat,
mass transfer etc)

The non-dimensional table takes non-dimensional U as entry, not flow rate

- runTimeModifiable change to the dictionary not being propagated to
  the underlying functionObjects

- problems when the cloud was not available on all processors.

- NB: ensight measured data only allows a single cloud, but
  foamToEnsight writes all clouds.

- these were previously taken from region-local directories
  (eg, constant/region/triSurface), but this becomes difficult to
  manage when there are many files and regions.

- The central InfoSwitch "writeLagrangianPositions" allows writing an
  additional Lagrangian "positions" file, but these were not being
  written by reconstructPar. These are now also written in reconstructPar
  if the central writeLagrangianPositions InfoSwitch is enabled.

NOTES

- "positions" are reconstructed from the processors "coordinates" file

- decomposePar will not attempt to create or redistribute any
  "positions" files

switch

The new lowReCorrection entry can be used to ensure that the low-Re
mode is only applied when its value is on/true, e.g.

    lowReCorrection      on;

When active, the low-Re mode is active when the local y+ is less than
the calculated y+_laminar.  When inactive, the high-Re form is employed
irrespectively of the local y+.

It has a defaulrt value of off/false for backwards compatibility with
OpenFOAM v1706

BUG: Fixing creating of turbulence after overset specific in createFields.H for overRhoPimpleDyMFoam